Nano V3 Arduino Compatible CH340 (pre-soldered)

An Arduino Nano clone. Works just as well but is much cheaper. Note, the header pins are already soldered.

Microcontroller Atmel ATmega328
Operating voltage (logic level): 5VDC
Input voltage (recommended): 7V ~ 9VDC
Input Voltage (limit): 6V ~ 12 VDC
Digital I/O Pins: 14 (of which 6 provide PWM output)
Analog Input Pins: 8
DC current per I/O Pin: 40mA
Flash Memory: 32KB (ATmega328) (of which 2 KB used by bootloader)
SRAM: 2KB (ATmega328)
EEPROM: 1KB (ATmega328)
Clock speed: 16MHz
The Arduino Nano V3 is supplied without a USB cable

This Arduino Nano clone works exactly the same as the original Arduino Nano and can be programmed with the Arduino IDE software. This is available for Windows, Mac, and Linux.

Download Arduino IDE

NOTE: This Arduino Clone is based on the CH340 USB chip. Sometimes it is necessary to install the driver for this for Windows or Mac. For Linux, this is rarely needed.

First, try if it works without installing the driver. If a COM port is available in the Arduino IDE where you can upload to, then everything is fine and nothing needs to be installed.

If necessary, you can download the required driver here:

Download CH340 driver for Windows

Download CH340 driver for Mac

Download CH340 driver for Linux

Disclaimer: Downloading and installing the offered drivers is an extra service from us and entirely at your own risk. We cannot guarantee that the offered drivers are up-to-date. Any malfunctions that arise from the use of these drivers are the responsibility of the person who installs the drivers.