Collection
A handy board to easily program your ATtiny chip. Suitable for: ATtiny13AATtiny25ATtiny45ATtiny85 Equipped with a...
Joystick Potentiometer Resistance Value 10K Ohm Resistance Tolerance ± 5% Rocker potentiometer Potentiometer sensing, very accurate Thin type...
This is a 2.42 inch OLED display module with a resolution of 128x64. These OLED graphic displays offer very good contrast and do not require a backlig...
UBS 2.0 cable from USB-A to Micro-USB Suitable for ESP32, Wemos and ESP8266 Length: 1 meter Dimensions Length: 100cmWidth:...
This toggle switch has 3 positions: ON, OFF, ON. The switch has 6 pins with which you can switch 4 wires. Specifications:</st...
0.91 inch mini OLED screen. Razor-sharp image with a resolution of 128x32 pixels. Works on a power source of 3v-5v. Ideal for Arduino or ESP32...
This PCM5102A is a Digital-to-Analog Converter (DAC) module is primarily intended for converting digital audio information into an analog audio signal...
This NodeMCU ESP32-U is equal in performance and features to the <a href="https://www.otronic.nl/a-59613972/esp32/esp32-wroom-4mb-devkit-v1-board-met-...
RFID TAG Type: MIFARE ClassicFrequency: 13.56Mhz Memory: 1K Suitable for <a href=https://www.otronic.nl/a-60634400/sensors/rfid-...
The DC-DC 12V to 3.3V 5V 12V Power Module is a flexible Buck Converter that adapts the power source before delivering it to the load. It provides 3 fi...
This adapter has an output of 5V with a maximum of 3A. The connection is a USB-A Female and can therefore be used for almost all USB charging cables o...
Some modules work with 3.3V I2C or UART, then this module can convert the voltage if your system works with 5V. (e.g. your 5V Arduino) This includes...
Material: Stainless steelMax. Switching Capacity: 2A @ 36VLED Voltage: 12V-24VLED Color: GreenButton Type: On-Off Self LockHole Diam....
This Breakout board for ESP32-S with screw terminals not only provides a convenient way to connect wires, but also makes testing multiple ESP32 device...
Solar panel input: 4.4-6VMax charging current: 500MaInterface: 2-pin JST connectors (or PH2.0)Short circuit protectionContinuous charging current...
Battery Management System (BMS) for a 4S battery pack. With this circuit you can safely make a battery pack from 4 series Li-ion/Li-Po batteries (cell...
Module that is able to follow lines using infrared sensor. Nice sensor, very suitable for...
40 Dupont Jumper Cables to connect two points on a breadboard or Aruino. The cables are grouped per 40 pieces as ribbon cable, and can be easily...
Voltage: 5 - 12 VDCMaximum current per channel: 500 mA This stepper motor driver provides a direct interface between a stepper motor and a...
A set of 600 resistors with 30 different values for your electronics project. <span style="color: rgb...
This adapter allows you to easily connect the ESP32 CAM via micro USB to your computer to program it. Dimensions Length: 3.94cm...