Mega 2560 R3 (Arduino clone)

This Arduino Mega clone has exactly the same functionality as the original Arduino Mega and can be programmed with the Arduino IDE software. This is available for Windows, Mac and Linux.

Download Arduino IDE

PLEASE NOTE: This Arduino Clone is based on the CH340 USB chip. Sometimes it is necessary to install the driver for this on Windows or Mac. On Linux this is actually rarely needed.

First try whether it works without installing the driver. If there is a COM port available in the Arduino IDE that you can upload to, then everything is already fine and nothing needs to be installed.

If necessary, you can download the required driver here:

Download CH340 driver for Windows

Download CH340 driver for Mac

Download CH340 driver for Linux

Specifications:
- Microcontroller: ATmega2560
- Operating voltage: 5V (via USB connection or power supply)
- Input voltage (recommended): 7-12V
- Input voltage (minimum/maximum): 6-20V
- 54 digital input/output pins of which 14 can be used as PWM.
- 16 analog inputs
- Maximum current per I/O pin: 40mA
- Maximum current for the 3.3V pin: 50mA
- 4 UARTs (hardware serial ports)
- 16MHz crystal oscillator
- a USB connector
- power connector
- ICSP header
- Reset button
- 256KB Flash memory
- EEPROM 4KB
- SRAM 8KB
The Mega is compatible with most shields designed for the Arduino Duemilanove or Diecimila.

Disclaimer: Downloading and installing the offered drivers is an additional service from us and entirely at your own risk. We cannot guarantee that the offered drivers are up to date. Any malfunctions arising from the use of these drivers are at the risk of the person installing the drivers.

Dimensions
Length: 10,9cm
Width: 5,32cm
Height: 1,14cm