Make your own Power Bank with this JX-887Y PCD 18650 Dual Micro USB 3.7V to 5V 2A Boost Power Bank DIY Dual USB Output. Ing...
With this little board you can control up to 8 i2c devices on one data line! Even if the i2c devices all have the same i2c address they are still...
Digital multimeter including test leads. This budget multimeter is indispensable for every electronics hobbyist. The dimensions of the multimeter...
11.1V 12.6V 20A 3S Lithium Battery Protection PCB BMS Board For 18650 18550 Li-ion Lipo Battery Cell Pack This lithium ion battery protection board...
Material: ABS impact resistant material Diameter: 21mm Wire length: 150 x 3mm Shaft diameter: 2mm Shaft length: 9mm Voltage: 3-6V Dimensions:...
This ESP32-U is equal in performance and features to the <a href="https://www.otronic.nl/a-59613972/esp32/esp32-wroom-4mb-devkit-v1-board-met-wifi-bl...
This S2 Mini is equipped with an ESP32-S2 chip. This has a clock speed of no less than 240Mhz. It also has integrated WiFi. Due to the clever layout...
small module with a heart rate sensor and SpO2 level (oxygen saturation level). The module is based on the MAX30102 chip and communicates via the I2C ...
Voltage: DC 5V Current: 10mA Liquid Temperature: Max 120°C Waterproof: IP65 Inlet Thread Diameter: G1/2 Male...
This educational wind generator DC Motor Set with Propeller is ideal for learning to understand the principle of a wind turbine, a dynamo and a DC mot...
Voltage: 3-3.6V Max output power: + 20 dBm Working current in transmit mode: 115mA Working current in receiver mode: 45mA Receiving...
This is a 2.42 inch OLED display module with a resolution of 128x64. These OLED graphic displays offer very good contrast and do not require a backlig...
Features:1. Standby control to save power.2. CW/CCW/short brake/stop motor control modes.3. Built-in thermal cut-out...
This module offers you the possibility to connect your Arduino to WiFi for a very low price. The ESP8266 module works with the normal...
High quality Dupont cable per meter. 40 cores (4x 10 sets of rainbow cable together) Easy to pull out if necessary. Use the meta...
A Peltier module that works on 12 Volt. You can heat or cool with it, simply by switching the polarity. Specification:Model: TEC1...
This uBlox GY-NEO6MV2 module gives your Arduino, ESP8266, Wemos or ESP32 the ability to communicate with satellites and determine its location. <ul...
The MG996R is a high quality digital servo with high torque metal gears and can be used for just about anything. This servo is a...
This Arduino Mega clone has exactly the same operation as the original Arduino Mega and can be programmed with the Arduino IDE software. This is avail...
Signal generators/function generators are super useful from RF to embedded logic but they are usually not super cheap. Good news: with this AD98...
Material: ABS impact resistant material Diameter: 21mm Wire length: 150 x 3mm Shaft diameter: 2mm Shaft length: 9mm Voltage: 3-6V Dimensions:...
Battery holder for 1x 3.7V round lithium 18650 battery. Dimensions Length: 7.6cmWidth: 2.1cmHeight: 2cm...