
The ESP32 development board is ideal for IoT (Internet Of Things) projects because it has onboard WiFi and Bluetooth. Simply via the Arduino IDE...
The ESP32 development board is ideal for IoT (Internet Of Things) projects because it has onboard WiFi and Bluetooth. Simply via the Arduino IDE...
The F5305S MOSFET electronic switch DC control board is based on the FET model of the new original F5305S. We can input a PWM signal...
The ESP32-C3 Super Mini is a compact IoT board with WiFi, Bluetooth, 32-bit RISC-V processor, 400KB SRAM, and various I/O pins. Ideal for wireless pro...
The SG90 Micro Servo is a high quality, small servo that is perfect for use in hobby projects and small robots....
This ultrasonic module can be used to create water vapor or mist by placing the ultrasonic module in a layer of water or on a wet sponge. 5V power sup...
0.91 inch mini OLED screen. Razor-sharp image with a resolution of 128x32 pixels. Works on a power source of 3v-5v. Ideal for Arduino or ESP32...
Arduino UNO R3 compatible board including USB cable and 40 header pins. To be used in the standard Arduino IDE software. This UNO R3 has exactly the s...
A set of 600 resistors with 30 different values for your electronics project. <span style="color: rgb...
High load possible: AC250V 10A / DC30V 10 A Relay control 5v 1 relay on PCB Suitable for Arduino / ESP32 / ESP...
Breadboard with 830 holes, an ideal size for larger experiments. Advice to purchase a breadboard power supply so that you always have...
Make your own Bluetooth speaker Or equip a traditional amplifier with Bluetooth With this small powerful board you can do that in no time....
This OTRONIC® adjustable time delay relay module has an adjustable switch-off (drop-out) delay....
Compact ESP32-C3 development board with 0.42 inch OLED display, 4MB flash, WiFi 802.11b/g/n, Bluetooth 5 LE, and low power consumption for various IoT...
A full-fledged ESP32 with a camera module and Micro SD card slot. The OV5640 camera module contains a 1/4 inch CMOS UXGA (1632 x 1232 pixels) image se...
HC-SR501 PIR Motion Sensor is an infrared motion sensor with the following specifications:– Detection distance: 3-7m.– Delay: 5-200s <b...
high quality step down power converter with an efficiency of 97.5% at 6.5v to 5V at 0.7A and relatively little heat development. The effi...
Set of pigtail connectors of the type JST PH with red black wire. Male and female cable are supplied as a set. Length of the wire is approx. 10cm...
This PWM to Voltage Converter Module is designed to convert PWM signals to voltage between 0-10V, and is suitable for a wide range of applications in ...
Bluetooth version 5.0 Music format: MP3 / WMA / WAV / FLAC / APE Power: 2 * (25) W, connect 2 (25) W speakers Radio FM frequency: 87.5-...
An Arduino Nano clone. Works just as well but is a lot cheaper. Note that the header pins are already soldered. Microcontroller Atmel ATmega328<br...
40 Dupont Jumper Cables to connect two points on a breadboard or Aruino. The cables are grouped per 40 pieces as ribbon cable, and can be easily...
3.7V 2000mAh Nominal: 3.7V to 4.2V <br>Equipped with built-in BMS and protected from overcharging and over-discharging.Cut-off: 2.75V</p...
Powerful ESP32 development board with USB-C and external antenna connector. Supports Wi-Fi, Bluetooth, up to 25 GPIO pins and is ideal for IoT, automa...























